HOME

PRODUCTS

RETROFIT

SERVICE

DOWNLOADS

ABOUT US

CONTACT

LIABILITY

German Flag

 

Control cabinets


Control cabinetsEspecially with larger machines, it is not advisable to integrate all components into the CNC control. Power supplies, drive amplifiers, relais logic and connector panel require a lot of space, which normally is not available where the CNC control and operators panel are located.
In addition, there is a thermal problem: although modern switching power supplies and high efficient amplifiers are used there is still waste heat which must be dissipated by the cabinet surface.

Almost any flame cutting machine looks different. From Woyda Elektronik you get Controls and control cabinets specially combined to your needs. Included are of course individually generated bills of material and drawings.

In our cabinets we only use components developed and produced by ourselves or components from well-known manufacturers for safety and reliability of our products.

Should you have special requirements for your cabinet, don't hesitate to contact us. We also constructed control cabinets for other machines and are experienced with connection powers up to 15kW

 


Woyda Elektronik CNC Steuerung NBS300 Brennschneidtechnik Woyda Elektronik CNC Steuerung NBS300 Brennschneidtechnik Woyda Elektronik CNCWoyda Elektronik CNC Steuerung NBS300 Brennschneidtechnik Woyda Elektronik CNC Steuerung NBS300 Brennschneidtechnik Woyda Elektronik CNCWoyda Elektronik CNC Steuerung NBS300 Brennschneidtechnik Woyda Elektronik CNC Steuerung